Leather usb key!
Made a leather usb key MOD in 10 steps
step 01: Choose some piece of leather. Select one and take your usb key.
step 02: Scissor leather following usb outline: Measure the length of your usb key and cut the leather accordingly.
step 03: Glue the leather Wrapping up usb key in it. Use spray adhesive glue: spray glue is easier to use because if you mess up you can begin again.
steps 04 & 05: Tear off ends.
step 06: Cut off ends except one.This one is to cover the bottom of the usb key
step 07: Glue the remaining end: separate glued sides and glue the remaining inside.
steps 08: Do the same for the top: cut off succeeding top edge except one. Next glue the last piece on the top.
step 09: Cut off the leather nearly following the top: just follow it.
step 10: Next, separate caerefully the top and the usb key.
Congratulations!! You made a lovely usb key protection.
Leave a Reply
You must be logged in to post a comment.
